NOTE: Non-PPPL employees may access these routines by following procedure GEN-034. This page was created by a MODIFICATION of the IDL library routine Local IDL Routines By Category Local IDL Routines P3d_misc_getinformation: Read the following values: P3d_misc_getinformation: KW(RDNOISE)="RDNOISE". P3d_misc_getinformation: KW(GAIN)="GAIN" , P3d_misc_getinformation: Read the following keywords from the instrument-specific header keywords file: P3d_misc_imcombine: block 4/4 :: Flipped the input data in the y-direction. P3d_misc_imcombine: block 3/4 :: Flipped the input data in the y-direction. P3d_misc_imcombine: block 3/4 :: Flipped the input data in the x-direction. P3d_misc_imcombine: block 2/4 :: Flipped the input data in the x-direction. P3d_misc_imcombine: Merging the data of all blocks. % READFITS: Now reading 1055 by 1035 array P3d_misc_read_params: Read blocksfx_4=" d". P3d_misc_read_params: Read blocksfx_3=" c". P3d_misc_read_params: Read blocksfx_2=" b". P3d_misc_read_params: Read nblocks=" 4" (->integer). P3d_misc_read_params: Read lampsfile_dm="/mnt/datos/ami/IAA/DATA/PMAS_mar10/100325/lineas_hgneB.dat". P3d_misc_read_postable: The output arrays contain totally 256 elements. P3d_misc_read_postable: Found 256 science elements in the position table file. P3d_misc_read_postable: Saving positions of science fibers. P3d_misc_read_postable: calibration element id:s :: > 900000 P3d_misc_read_postable: sky element id:s :: > 800000 P3d_misc_read_postable: no use element id:s :: 1000000 P3d_misc_read_postable: shape, nvertices, scale, xisw2e, xfac, yfac :: 0, 15, 1.00, 0, 1, 1 P3d_misc_read_params: Read postable="larr4k_positions.dat". P3d_misc_read_params: Read deadfibersfile="larr4k_dead_fibers.dat". P3d_misc_read_params: Read gratingsfile_dm="pmas_gratings.dat". P3d_misc_read_params: Read keywordsfile="pmas_keywords.dat". P3d_misc_read_params: Read daxis=" 1" (->integer). P3d_misc_read_params: Read blocksfx_1=" a". Copy & Paste from what I get on the screen: setup that I have: LARR, new CCD as said in the summary From what I read in my terminal (and which I will copy below, using "debug" and "print the maximun information" options, I have the impression that p3d reads the file but does not want to use it unless one explicitly select it in the second window. But then a small window appear and disappar (not time to read it and to make a snapshot to be attached) and another window appear asking me again for the line list. Lampsfile_dm /mnt/datos/ami/IAA/DATA/PMAS_mar10/100325/lineas_hgneB.dat I want to always use a cleaned line list for wavelenght calibration, so I put it in my user_p3d.prm file.